![]() Motion Sensing platform will be configured when first turned on.After completing it will automatically restart.Once the device is powered up it will enter self configuration mode.When the update counter reaches “100%” the device will automatically restart.In the “Firmware Update” dialog box select “Yes” to start the update.Download the ***.bin file from and copy to your microSD Card - root directory.To ensure your zero coordinates are not lost, write down your zero coordinates before continuing to update the firmware. This will corrupt the system files and the device will need to be sent back to the ATN factory for service. In the event of a power failure during an update, the device may crash. To update the firmware you will need a microSD Card and fully charged internal battery. An email notification will be sent when a new firmware update becomes available. To receive a notification concerning new firmware updates, please register your device on our website. ![]() If you are going to record video, the microSD Card should be a Class 10 (10 Mb/sec) or faster and have capacity from 4 to 64 Gb that is an HC type SD card.īefore operating your device, update the firmware to the latest version. When the card pops up a few millimeters, pull the card out with your fingers or tweezers. To remove the microSD Card from the port, push the card slightly in using the same thin object you did before. There is only one correct direction to insert the microSD Card.ĭo not force the microSD Card into the port doing so may cause damage to both the scope and the card itself. Return the cover to its original position.Use a thin object (small coin, paper clip) to lock the microSD card in place after inserting it into the slot.Always format a new microSD card before using.Make sure that the device is turned off before inserting the formatted microSD Card into its assigned port. To open the rubber port cover, gently lift the rubber cover and move it out of the way. You can find them under the rubber caps on the right side of the device (we marked the caps with appropriate icons). The device is equipped with a microSD Card and USB (type C) ports. Battery run time is 18 hours on a single charge.Battery charging time (from 0 to 100%) is 6 hours with 2 A USB charger.Note using a wall charger with lower amperage will take longer to charge your scope. ![]() Plug the cable into a USB wall charger that has an output of 2 amps (Wall Charger not included).Ĭharge your scope for 6 hrs using a 2A USB wall charger. We have included a USB (type C) charging cable with your scope. You will find it under the rubber cap on the right side of the device (caps are marked with appropriate icon). ![]() The device is equipped with a USB (type C) port. If any accessories are missing or broken contact ATN’s Customer Service at 1.800.910.2862.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |